Operating Manual

Table Of Contents
Operator’s Manual M365-491
7-2 Chapter 7
October/2005 Regulatory, Wireless Interoperability, and Health Information
WARNING
Changes or modifications to this device not
expressly approved by Miltope Corporation
could void the user’s authority to operate the
equipment.
Miltope Corporation is not responsible for any interference caused by unauthorized modification of
the CAP, or the substitution or attachment of connecting cables and equipment (antennas) other than
that specified by Miltope Corporation.
The correction of interference caused by such unauthorized modification, substitution or attachment
is the responsibility of the user/installer.
WARNING
Exposure to Radio Frequency (RF) Radiation
In accordance with FCC requirements of human
exposure to radio frequency fields, the radiating
element shall be installed such that a minimum
separation distance of 20 cm (8 inches) is
maintained between it and the user or general
population.
Taiwan - Directorate General of Telecommunications (DGT)
a. The low power radio frequency regulations issued by Ministry of Transportation and
Communications in Taiwan state the following requirements:
Clause 14: For certified low power radio frequency electric machinery, companies, firms, or
users shall not change the frequency, increase the power, or change the features and functions of
the original design without permission.
Clause 15: Any use of low power radio frequency electric machinery shall not affect the aviation
safety or interfere with legal communications. In event that any interference is found, the use of
such machinery shall be stopped immediately, and using of such products should resume only
after improvements are made to eliminate all interference caused.
The legal communications mentioned above refer to radio communications operated in
accordance with telecommunication laws and regulations. Low power radio frequency electric
machinery shall tolerate legal communications or interference from radiological,
electromechanical devices for industrial, scientific, and medical uses.