User Manual

200 West Street phone: [phone]
Waltham, MA 02451 fax: [phone]
USA
CM9-C1 Installation
MODULAR USAGE
This device is intended only for installation into the Miltope
Cabin Access Point (CAP) under the following conditions:
1) The antenna must be installed such that 20 cm is
maintained between the antenna and users.
2) The transmitter module may not be co-located with any
other transmitter or antenna
3) The final product containing this device must be labeled
in a visible manner with the following; “ Contains FCC ID
RTP550-10016-7”
4) The end product user manual must contain the following
information in a prominent location; “Important Note: To
comply with FCC RF exposure requirements, the
antenna used for this transmitter must be installed to
provide a separation distance of at least 20cm from all
persons and must not be co-located or operated in
conjunction with any other antenna or transmitter.
5) This radio module is approved for use only in the Miltope
CAP (Cabin Access Point) which is deployed only in
aircraft and is professionally installed per FAA
regulations.