User's Manual

4 Aruba 303H Series Hospitality Access Point | Installation Guide
LED Display Settings
The LEDs have three operating modes that can be selected in the system
management software:
z Default mode: Refer to Tables 1-3
z Off mode: LEDs are off
z Blink mode: LEDs blink green
Figure 2 Back Panel
Console Port
The 5-pin USB Micro-B connector located on the back of the access point allows for direct management of the
device when connected to a laptop or serial console. For pin-out details, refer to
Figure 3.
Figure 3 Console Port Pin-out
Ethernet Ports
The AP-303H access point is equipped with four active Ethernet
ports (E0-E3). Refer to
Figure 4.
E0
57V 600mA
PT

The rear panel of the AP-303H may become hot after extended use.
1 2 3 4 5
1: NC
2: RX
3: TX
4: GND
5: GND
USB Micro-B