Installation Guide

SAFEmine Ltd | www.safe-mine.com | [e-mail] 22/39
SAFEmine (part of Hexagon Mining)
Baarerstrasse 133, CH-6300 Zug
Switzerland
www.hexagon.com
3.6.5. QM105 Power Saving Display Cable
The QM105 Power Saving display cable is used to power the QD204 ScopeScreen from ignition, in
order to safe power when the ignition is turned off. The CAS MainUnit will remain powered on thanks
to its direct connection and continues to provide its service regardless of the ignition status. The
cable features a male and a female M8 plug with 4 pins and 2m open ended pigtail to connect to a
ignition switch controlled power supply.
3.6.6. QM106 RS232 Serial Communication Y-Cable
The QM106 is used to access the main serial connection of the QC220 QC24X and QC250
MainUnits. The cable features a male and a female M12 connector with 8 pins each and a 4 pin M8
female connector for the serial connection. This cable serves for both, connecting the displays or
programming the units via serial programming cable. The pinout of this cable corresponds to the
pinouts of the main and serial interfaces of the CAS units respectively. Please refer to their
documentation in this chapter. This cable replaces the QM109 cable
3.6.7. QM108 Speaker Power and Audio Signal Y-Cable
The QM108 Speaker Power and Audio Signal cable is required for SAFEmine Voice installation and
connects the CAS MainUnit to the QL015 Loudspeakers. The cable features 2 female and one male
M12 connectors.
3.7. Network
SAFEmine QC220, QC24X and QC250 MainUnits can provide vehicle tracking functionalities if
connected to a SAFEmine Track server (SMTrack). The Movements and status of the vehicles can
be consulted through the web interface of the SAFEmine Track server.
For additional information consult chapter Error! Reference source not found. of this manual.
The following information can be tracked and recorded:
 Vehicle Position
 Vehicle-ID
 CAS MainUnit serial number
 Installed firmware version and build number
 Power supply voltage
 State of the digital inputs and outputs (seatbelt, handbrake, idling, motor hours, etc.)
 Value of the analog inputs (bucket load, fuel gauge, etc.)
Please consult with your SAFEmine Support contact if you plan to implement this function or write to
[e-mail] for further information on this product.