HXSP-1001 RS-232/485/422 serial device server user manual
【Summarize】 HXSP-1001 is a serial device server which can connect with network fast. it provides one RS232/485/422 (RS-232: DB9M; RS-484/422: 4 bits terminal block) and 1 10Base-T Ethernet port, it can manage the disperse serial device or host computer by network, easily and convenience. setting or software upgrade by serial program group in apply, support TCP, UDP, ARP, ICM and DHCP protocol, support Windows Native COM and auto-connect function once the network intermit.
Port memory: 512 byte Transmit distance: 100m Interface protection: 1.5KV ESD Interface type: RJ-45 Serial NO.of ports: RS-232,RS-422/485 4 bits terminal block RS-232 signal: TxD, RXD, RTS, CTS, DTR, DSR, DCD, GND RS-422 signal: Tx+, Tx-, Rx+, Rx-,GND RS-485 signal: Data+, Data-,GND Parity: None, Even, Odd, Space, Mark Data bit: 7bit,8bit Stop bit: 1, 1.5, 2 Transmission speed: 1200bps ～ 115200bps Flow control: support RTS/CTS flow control or not flow control.
RJ 45 port support automatic MDI/MDI-X operation. can connect the PC , Server, Converter and HUB by straight–though cable wiring . Pin 1, 2, 3, 6 Corresponding connection in MDI. 1→3, 2→6, 3→1, 6→2 are used as cross wiring in the MDI-X port of Converter and HUB. 10Base-T are used in MDI/MDI-X, the define of Pin in the table as below.
Obverse: LED indicator show: Electrify input: Status1and Status2 blinking 3times Main mode undiscover target facility: Status2 blinking, 1 /sec Data transmit: Status2 off No data transmit: Status2 on Setting error: Status1 blinking, 1/sec data buffer full: Status1 on 【Simply use setting】 Introduction the equipment simple use as following(visit the facility by create a dummy serial port ). Running the serial connection wizard, interface display as below. Setting step by step.
Step 3: Default Item , select the create a new VSP (COM) . Then click “Next” Step 4: Default Item, and then click “Select from the list” Step 5: Select your target corresponding IP from list, click “Select” Step 6: After select the target, back to interface. Click “Next” Step 7: Select the working mode.
client server mode（2）serve mode（3）free choice mode Step 8: click on “Next”. Step 9: Select the TCP/IP transport protocol suppose the listening port on the device serve is a default port (1001), click “Next”. Step 10: Select the “Yes, enable on-the fly commands, use out–of –band access” . Click “Next”.
Continue click the “finish” in the next step. Note: Advance setting steps and methods refer to the user manual document in CD. 【Device Installation】 Pay attention to the questions as below ： (1) Make sure the power adapter is 9V； (2) Use the cross-over cable if the devices connect to the PC. (3) Use the straight-through cable if the devices connect to the HUB. Note: Cable (blue) with the product is a straight-through cable. 【Application】 Project 1.
the facility after waiting 20 minutes. MAC address bind：When PC carries on the correspondence with some equipment, If discovered that this equipment's IP the address was been already obsolete by other equipment use， PC machine will think that this equipment IP address existence conflict is unable with this equipment to carry on the normal correspondence。 【operate in application】 In the search, establishes in equipment's process, involves operates as follows : 1.
