HXSP-1004 4 ports RS-232 or RS-485/422 serial device server user manual
【Summary】 4 ports serial device servers which can contact with network fast. it provides one line RS-232/485/422 (RS-232: DB9M: RS-484/422 / 4 bits terminal block) and 1line 10Base-T, it can manage the disperse serial device or host computer by network, easily and convenience. Setting or software upgrade by serial program group in applying. Support TCP, UDP, ARP, ICM and DHCP protocol, support Windows Native COM and auto-contact function once the network intermit.
Interface protection: 1.5KV ESD Interface type: RJ-45 Serial interface EIA RS-232, RS-485, RS-422 standard RS-232 signal: TxD, RXD, RTS, CTS, DTR, DSR, DCD, GND RS-422 signal: Tx+, Tx-, Rx+, Rx-, GND RS-485 signal: Data+, Data-, GND Parity: None, Even, Odd, Space, Mark Data bit: 7bit, 8bit Stop bit: 1, 1.
DC-IN: 5VDC power supply input 10/100M Ethernet: 10/100Base-T(X) Ethernet input and output ACT LED indicator: Bright all along when connect power supply LINK LED indicator: Bright all along when connected RX/TX LED indicator: Bright all along when connect to the network, Flash when data transfer 1, 2, 3, 4: RS-232 port (HXSP-1004A), RS-485/422 port (HXSP-1004B) 10/100Base-T Ethernet port The 10/100BaseT(X) ports located on facility front panel.
PIN 1 2 3 4 5 6 7 8 RS-232 TXD RXD RTS CTS DSR SG DTR DCD RS-485 RS-422 D+ RX+ TX+ DRX- GND TX- FULL GND 【Software installation and setting】 1 Set the IP address of the device The IP address of the device and the PC must in the same subnet network (the default IP address of the device is 192.168.1.233). First, must make the IP address of the device in the same subnet network of PC.
keyboard and quit by “ESC” key. 3 Choose the “Server” menu and push “Enter” key, Change the IP of the device. 4 Change the IP (the changed IP must be in the same subnet of the PC). Push “Esc” key, quit the network setting.
6 Push “Enter” Key, save the setting. 2. Create the Virtual COM port on the PC Setup the “setup_nt_2K.exe” software, then you will find the “COM port over tcp/ip.exe” application in the control panel of windows OS. Running the “COM port over tcp/ip.exe” application and create virtual COM port communicate with the device on the PC.
1 Input the IP of the device 2 Input the NO. of the port of the device(Input 1~8) 3 Input 300 4 Default the parameter Click the “OK”, Click “Save”. COM5 has been created. Now, the COM5 can communicate port of the device. with the terminal on the NO.
(1) Please make sure that the power adapter is 5VDC (2) When connect to PC, use cross-over cable. (3) When connect to HUB or Switch, use straight-through cable 【Installation】 Note: Pay attention to the questions as below: (1) Please make sure that the power adapter is 5VDC (2) When connect to PC, use cross-over cable.