Parts List

INITIAL INSTALLATION

4. Loosen all four mounting brackets screws (W),

then completely remove the two mounting bracket

screws (W) from the round holes of canopy (D). Set

aside for later use.

Detach mounting bracket (E) from canopy (D).

Note: Do NOT remove the mounting bracket screws

(W) from the slotted holes.

5. Extend the supply wires from outlet box (not

included) to one side of the mounting bracket (E)

and secure the mounting bracket (E) to the outlet

box using screws and washers provided with the

outlet box.

CAUTION: It is very important you use the proper

hardware when installing the mounting bracket (E) as

this will support the fan.

Note: Do not feed supply wires through the hole in the

top of the mounting bracket.

Important: If using the angle mount, ensure the open

end of the mounting bracket (E) is installed facing the

higher point of the ceiling.

6. Remove all ten preassembled motor screws (U) and

vepreassembedmotorblocksfromtheundersideof

the motor assembly (G). Then install the blade arms

(N) into the underside of the motor assembly (G)

using the ten motor screws (U).

Discard the motor blocks.

For Standard or Angle Mounting Instructions, continue

to page 9. For Closemount Instructions, proceed to

page 11.

Standard or

Closemount

Mounting

Angled

Mounting

Motor

Block