Parts List

CLOSEMOUNT INSTRUCTIONS

1. Remove and discard the canopy cover (F) from the

bottom of the canopy (D).

Note: The downrod (A) and canopy cover (F) are not

used in this type of installation.

2. Remove the three Phillips-head closemount screws

(Y) from the top of the motor assembly (G). Align

the canopy (D) with the holes in the top of motor

assembly (G), then re-install the Phillips-head

closemount screws (Y) to secure the canopy (D) to

the top of the motor assembly (G).

3. Raise the fan and place the canopy (D) on the hook

on the mounting bracket (E) temporarily leaving hands

free for the wiring process. Then, place the receiver

from remote pack (P) inside the mounting bracket (E)

withatsidefacingtheceiling.

WARNING: Using a full-range dimmer switch to

control fan will cause a loud humming noise from the

fananddamagetheremote.Toreducetheriskofre

or electric shock, do NOT use a full-range dimmer

switch to control the fan speed.

Receiver