Installation guide

7
Chapter 2: Hardware Setup
b
Slidethe2.5"DiskHolderintotheharddrivebay,andpushitallthewayuntilthedriveisrmlyconnected
to the SATA connector. Secure the Disk Holder with the provided screws.
3
Repeat the steps above to install the other drive if you have prepared one.
4
The position of drives is as follows:
Note:
If you want to create a RAID volume, we recommended that all installed drives are of the same size to make
the best use of drive capacity.
5
Replace the upper case, and tighten the screws on the back panel.