Datasheet

19
TS-x51 Series. Powered by QNAP's Exclusive QvPC Technology
AC mains
AC mains
AC mains
UPS supporting
SNMP
UPS
UPS
WiFi Router
UPS support
Switch
TS-x51
TS-x51
TS-x51 (UPS Master)
Low power shutdown signal
WiFi Router
USB signal
detection
USB signal
detection
UPS AC power
UPS AC power
UPS AC powerUPS AC power
Ethernet
Ethernet
Ethernet
UPS AC powerUPS AC powerUPS AC power
UPS AC power
UPS AC powerUPS AC power
TS-x51 (UPS Slave)
TS-x51 (UPS Slave)
AC mains
AC mains
AC mains
UPS supporting
SNMP
UPS
UPS
WiFi Router
UPS support
Switch
TS-x51
TS-x51
TS-x51 (UPS Master)
Low power shutdown signal
WiFi Router
USB signal
detection
USB signal
detection
UPS AC power
UPS AC power
UPS AC powerUPS AC power
Ethernet
Ethernet
Ethernet
UPS AC powerUPS AC powerUPS AC power
UPS AC power
UPS AC powerUPS AC power
TS-x51 (UPS Slave)
TS-x51 (UPS Slave)
Uninterruptible Power Supply (UPS)
Activate the UPS support to ensure the Turbo NAS is properly shutdown if power fails. In the event of a power failure the
Turbo NAS will shut down automatically or enter auto-protection mode by probing the power status of the connected UPS
unit. You can set up the function by clicking QTS [Control Panel] > [System Settings] > [External Device] > [UPS].
￭
Case study for NAS connecting to a USB UPS
You can set the Turbo NAS to shut down or enter auto-protection mode if the power fails, and determine the action after
few minutes of the power failure. Once the auto-protection mode is activated, the Turbo NAS will revert to the state
before power failure and continue to operate when the power restores.
￭
UPS with SNMP management
When the Turbo NAS and the SNMP-based UPS server connect to the same network, you can select [SNMP connection] and
enter the IP address of SNMP UPS server to set up the power failure notification.
QTS 4.1 OS