Datasheet

20
TS-x51 Series. Powered by QNAP's Exclusive QvPC Technology
AC mains
AC mains
AC mains
UPS supporting
SNMP
UPS
UPS
WiFi Router
UPS support
Switch
TS-x51
TS-x51
TS-x51 (UPS Master)
Low power shutdown signal
WiFi Router
USB signal
detection
USB signal
detection
UPS AC power
UPS AC power
UPS AC powerUPS AC power
Ethernet
Ethernet
Ethernet
UPS AC powerUPS AC powerUPS AC power
UPS AC power
UPS AC powerUPS AC power
TS-x51 (UPS Slave)
TS-x51 (UPS Slave)
￭
Multiple NAS units share USB UPS
The network UPS "master" is connected to the UPS via USB cable. If the power fails, the UPS sends a notification to the
network UPS "master" via USB and all the UPS "slaves" are informed by the UPS master via Ethernet. To set your Turbo NAS
as a UPS "slave": connect the UPS and the Turbo NAS by USB, select [NetworkUPS slave], enter the IP address of the master
server, so the slave server will get notification when the power fails.
Step 2: Enter the IP address of
the master server
Step 1: Select "Network UPS slave"