User manual
Table Of Contents
- Table of Contents
- Safety Warnings
- CPU and Memory Specifications
- Power Button and Reset Button Behavior
- USB One Touch Copy
- LED and Alarm Buzzer Specifications
- Upgrade Memory on QNAP Turbo NAS (RAM Module Installation)
- Network Expansion Card Installation
- Install an mSATA Flash module to the NAS.
- Hot-swap Hard Drives
- RAID Recovery
- Use the LCD Panel
- Install Power Supply Unit
- Technical Support
- Appendix A. Product Compliance Class
- GNU GENERAL PUBLIC LICENSE
5. Loosen the screw and remove the expansion slot cover.
6. Insert the network expansion card to the PCIe slot until it cannot go any further. Then
fasten the screw.
7. Push back Motherboard Drawer. Then fasten the screw.
8. Connect the power adaptor and cables to the NAS.
9. To check that the network expansion is recognized by the NAS, power up the NAS and
login the web interface as an administrator. Go to “Control Panel” > “System Settings”
> “Network” > “TCP/IP” and check the total number of network interfaces.
28