Installation Guide

Check Building Codes

• When installing, operating and maintaining your stove, follow the guidelines presented in

these instructions, and make them available to anyone using or servicing the stove.

• Your city, town, county or province may require a building permit to install a solid fuel

burning appliance.

• In the U.S., the National Fire Protection Association's Code, NFPA 211, Standards for

Chimneys, Fireplaces, Vents and Solid Fuel Burning Appliances, or similar regulations, may

apply to the installation of a solid fuel burning appliance in your area.

• Always consult your local building inspector or authority having jurisdiction to

determine what regulations apply in your area.

Before installing your stove

You need to consider the following to ensure the safe operation of your stove:

• Provision of adequate air to support efficient combustion of the fuel

• A well-sealed flue/chimney system, herein after referred to as the "flue system"

• The protection of combustible materials in proximity to the stove

Adequate air provision

It is essential for the safe and efficient use of your stove that you provide an adequate air supply

when lighting a fire, especially if there are extraction units such as cooker hoods or clothes

dryers in the vicinity. Crack the door open a little and allow air to enter. Once the air in the stove

and the flue stabilize, you can then close the door of the stove. Failure to do so will mean that

fuel is burned inefficiently, causing smoke and blackening the glass and may also cause smoke

to come back into the room.

Installation

Unpacking and preparing your stove for installation:

Assembling the HF-905U

1. Open the door and unfasten the wire on the fire fence. It is used to ensure that the glass

does not break during transportation.

3. Remove and check the following contents (spare parts found in ash pan):

 Instruction manual

 Spare glass clips – 2 pc

 Spare screws (M5 x 8mm)– 2 pc

 Wooden handle – 1 pc

 Wooden handle holder – 1 pc

 Ash pan

 Operating tool – 1 pc

 Rope gasket

 Wrench

 Mitten

If you purchase the HF905U with log storage pedestal, there will be another box which

marked the Log Storage Pedestal.

4. Fix the flue collar on the outlet which you selected by using the M6 x 20mm

flat crosshead

screw. Ensure all seals are secure to prevent air leakage. If you choose the rear flue outlet,

remove the flue cover before fixing the flue collar.

5. Fix the wooden handle on the stainless steel door handle with the M8 x 90mm bolt.

6. Keep the rest of the screws and Allen wrench for future use.