User's Manual

Installation

Seal Installation

Tanker Truck Monitoring System- User’s Guide 33

1. Verifying responses of all seals.

2. Planning the location of the communication units (Reader, LCU 500, antennas, etc.), in the

truck cabin.

3. Seal Status Indicator placement.

4. Layout and routing of cables.

5. For fiberglass cabins only – installation of metal bracket for antenna

6. Placement of AVL Reader, LCU 500, Protection Unit and cable connections

7. Verifying system installation

3.2 Seal Installation

3.2.1.1 Filling Hatches Installation

1. Remove all previous installations (handles, chains, etc.)

2. Place the Locking unit and the seal housing on the two opening plates so that the locking

unit is located on the upper plate and the installation tool - while still in the seal housing - is

located on the lower plate.

3. Move the Locking unit knob towards the installation tool (refer to Figure

3-1).

NOTE: Make sure the installation tool is touching the side of the upper plate and is adjacent to it

Figure 3-1. Locking and Seal Housing Units

4. Weld small footholds to the locking unit and the seal housing without damaging the

installation tool.

5. Remove the installation tool and weld the locking unit and the seal housing.

6. After the units cool off, use the micro-reader to verify that the seal is functional; temporarily

install the seal as illustrated in Figure

3-2 and perform a reading.

Lockin

Unit