User's Manual

Setup and Analysis
Fleet Management SW
Tanker Truck Monitoring System- User’s Guide 44
Figure 4-5. Sites Tab
2. Click Add and enter all the relevant refineries with coordination and geo-fence according to
the following parameters:
Name Name of site
Longitude Longitude coordinates of site
Latitude Latitude coordinates of site
Eps. Longitude
Eps. Latitude
Mask
4.2 Fleet Management SW
• Verify (using the Fleet Management SW) that the command (Get Status) of the unit
invokes the appropriate response. (i.e. location). If OK, means there is com with the server
in both directions.
• Make sure all seals are closed. And then perform SET.
• Verify that all LEDs are green.
• Open each of the seals, hatches and valves. Verify that the correct status is received at the
fleet application.
Are these options
relevant when
clicking “Read”
button?