User's Manual

Page 4 of 7
3. Installation Instructions
1. Unscrew the front panel screws and carefully dismantle
the top cover of the Compact Reader.
2. Insert power * and RS485 communication cable
(from PSC unit) through the left cable gland.
* 24VDC for IG-CR-46D-XXX, 48VDC for IG-CR-86D-XXX
3. Wire J1(screw-on terminal block) as shown figure1.3 (page.4)
4. Ensure cables are properly wired, tighten the cable glands
to obtain optimum sealing.
5. Connect the RS232 communication cable from the PSC unit
to the PC (COM port)
6. Switch on the external power supply, observe the Power indicator (on
the bottom side of the Reader) - the indicator flashes for approximately
5 seconds and remains illuminated.
Top cover screw
Cable Glands