User's Manual

Hi-G-Tek Ltd. Wireless Monitoring Platform for Security & Management Pg.4
Peel the paper from the three pieces of
double-sided tape: The two larger pieces
(Items #3 & #4) are used for holding the
DataTag to the tagged object while the
smaller piece in the middle (Item #5) are
used for pulling the Sensor Plate off the
DataTag in order to create the TAMPER
event when the DataTag is removed from
the tagged object.
Placing the DataTag on the vehicle
Note: The Installation instructions refer to the case when the DataReader is
installed VERTICALY.There are two preferred orientations for placing the
DataTag on the vehicle:
Horizontal Orientation:
Place the tag on a flat surface that is
completely horizontal and press firmly
to create good contact between the DataTag
and the tagged object.
Vertical Orientation
Place the DataTag on a flat surface that
is completely vertical and press firmly to
create good contact between the DataTag
and the Tagged object.
It is recommended that the height of the
DataTag above ground will be above 3’
and the optimal height is 5’ above ground.
3 5 4