User's Manual

- 23 -
4.7 Write Data – writing data to the DataSeal
Figure 11 Write Data Screen
When hitting the Write Data button on the main screen the user is prompt select the target
DataSeal, and then after the application displays the Write Data screen.
The purpose of the Write Data screen is to enable the user to modify the data fields in the
DataSeal after it has been “armed” (Set). Typically, the user will perform this operation if
some mistake was made putting the data in Set
screen.
The application reads first the fields from the DataSeal and displays them the user. Then the
user can modify the data fields (container ID, Shipment Number, etc …) hit the EXEC
button. The data the user enters is validated against the validation rule in the application
settings.
The user can choose to write the container ID only using the Options menu.