8.7 Secure Series Tags Active Fixed RFID Interrogator CLIN: 0001AA Installation & Operation Manual Delivering Global Visibility. Unisys Proprietary Notice This document contains Hi‐G‐Tek Inc. proprietary confidential information and may not be used or disclosed to other parties in whole or in part without prior written authorization from Hi‐G‐Tek Inc. UM 4901_Rev 1.
Disclaimer and Limitation of Liability Hi‐G‐Tek Inc. affiliates, officers, directors, employees and agents provide the information contained in this Manual on an “as‐is” basis and do not make any express or implied warranties or representations with respect to such information including, without limitation, warranties as to non‐infringement, reliability, fitness for a particular purpose or application, usefulness, completeness or accuracy. Hi‐G‐Tek Inc.
Installation & Operation: Active Fixed RFID Interrogator FCC Warning Modifications not expressly approved by the manufacturer could void the user authority to operate the equipment under FCC Rules. Instructions concerning human exposure to radio frequency electromagnetic fields: A distance of at least 20cm. between the equipment and all persons should be maintained during the operation of the equipment.
Installation & Operation: Active Fixed RFID Interrogator Table of Content 1 2 Introduction ...................................................................................................................................................... 5 Installation ......................................................................................................................................................... 5 2.1 Mounting the Fixed RFID Interrogator..........................................................
Installation & Operation: Active Fixed RFID Interrogator 1 Introduction The 18.7 Series Active Fixed RFID Interrogator is designed to monitor 18.7 Secure Series Transponders.
Installation & Operation: Active Fixed RFID Interrogator Wall mounting installation • The interrogator has to be installed vertically at a height of about 6ft. above ground. • Use supplied wall attachment accessories to attach unit to the wall. • Once properly aligned, mark 4 drill holes through the mounting bracket. • Mount the device using 4 sheet metal screws No.12 x 1.5” inserted into corresponding standard plastic anchors. Figure 2: Wall mounting the interrogator 2.1.
Installation & Operation: Active Fixed RFID Interrogator 2.1.2 Connecting hookup cables Connection of cables to the Interrogator is achieved from the bottom of the unit – see Figure 4. PWR RS485-B ETHER RS485-A RS232 DCIN FUSE ACIN Figure 4: Bottom view of Interrogator The bottom of the unit contains the following connectors and accessories: • Power ON indicator LED. • Power fuse. • DC In connector: 12 to 30 Volt dc. • AC In connector: 100 – 250 VAC 50 ‐60 Hz.
Installation & Operation: Active Fixed RFID Interrogator 2.2 Installation accessories and connecting cables Item / HGT’s Model # Description CLIN 0001 Active Fixed RFID Interrogator 0001AB – Mounting Kit • Compliant mounting kit In Accordance With (IAW) DoD requirements. • Flexible surface mounting for short‐term and long‐term installations.
Installation & Operation: Active Fixed RFID Interrogator Item / HGT’s Model # DC/DC Power Cable Hi‐G‐Tek, Model# = IG‐RF‐ACC‐04 Description DC power cord for Fixed RFID Interrogator Provided along with “Alligator “ clips • RS485 communication cable, plug type‐RJ45 , IP68 rated Hi‐G‐Tek, Model # = IG‐RF‐ACC‐10 UM 4901_Rev 1.
Installation & Operation: Active Fixed RFID Interrogator 3 Technical Specifications Communications • Operating frequency • Omni Directional read/write range Memory Memory size Data retention Power Requirements AC Mains DC Mains Input Power Control Interfaces RS‐232 Ethernet interface RS‐485 Environmental Operating temperature Storage temperature Hardened weatherproof 433.
Installation & Operation: Active Fixed RFID Interrogator • • • • • Standards FCC part 15 sub part B class B, sub part C section 15.