User's Manual Part 1
Table Of Contents
- Page 1
- Page 2
- Page 3
- Page 4
- Page 5
- Page 6
- Page 7
- Page 8
- Page 9
- Page 10
- Page 11
- Page 12
- Page 13
- Page 14
- Page 15
- Page 16
- Page 17
- Page 18
- Page 19
- Page 20
- Page 21
- Page 22
- Page 23
- Page 24
- Page 25
- Page 26
- Page 27
- Page 28
- Page 29
- Page 30
- Page 31
- Page 32
- Page 33
- Page 34
- Page 35
- Page 36
- Page 37
- Page 38
- Page 39
- Page 40
- Page 41
- Page 42
- Page 43
- Page 44
- Page 45
- Page 46
- Page 47
- Page 48
Hi-G-Tek Ltd. Microelectronics & Asset Tracking Technology
13
Table of Contents Page
7.8. Performing General Commands Cycles.
7.8.1 Selecting a Reader.
7.8.2 Selecting a Command
7.8.3 Defining Seals
7.8.4 Setting the System Session Duration
7.8.5 Setting the Command Parameters.
7.8.6 Single or Continuous Sessions.
7.8.7 Commands.
187
188
188
189
190
191
189
187
7.8.7.1 Verify Command
7.8.7.2 Tamper Command
7.8.7.3 Addressed Verify
7.8.7.4 Set
7.8.7.5 Soft Set
7.8.7.6 Suspended Set
7.8.7.7 Read Data
7.8.7.8 Write Data
7.8.7.9 Read Parameter
7.8.7.10 Write Parameter
7.8.7.11 Reset Data
7.8.7.12 Deep Sleep
7.8.7.13 Hard Wakeup
7.8.7.14 Start Alert Burst
7.8.7.15 Start Alert Burst (all)
193
193
194
191
196
197
198
199
200
200
201
201
202
203
7.8.7.16 Stop Alert Burst
7.8.7.17 Stop Alert Burst (all)
7.8.7.18 Ack Alert
7.8.7.19. Read Events
204
205
204
206
195