User's Manual
Table Of Contents
- Page 1
- Page 2
- Page 3
- Page 4
- Page 5
- Page 6
- Page 7
- Page 8
- Page 9
- Page 10
- Page 11
- Page 12
- Page 13
- Page 14
- Page 15
- Page 16
- Page 17
- Page 18
- Page 19
- Page 20
- Page 21
- Page 22
- Page 23
- Page 24
- Page 25
- Page 26
- Page 27
- Page 28
- Page 29
- Page 30
- Page 31
- Page 32
- Page 33
- Page 34
- Page 35
- Page 36
- Page 37
- Page 38
- Page 39
- Page 40
- Page 41
- Page 42
- Page 43
- Page 44
- Page 45
- Page 46
- Page 47
- Page 48
DataReader Installation
3
3.1 Outdoor DataReader Installation
3.1.1. Connecting the Outdoor Unit
The DataReader should be mounted on a smooth, flat surface.
To mount the unit, insert 4 screws into the slots on the unit and
fix to the surface.
A 6mm plastic anchor and 35mm pan head tapping screw
is recommended.
Remove the cover on the bottom portion of the DataReader unit
cover by removing the screws holding it in place.
Expose the wires in the cable and insert them into the terminal
blocks. Use a small screwdriver to push the wires in. Ensure wires
are inserted in the slots in accordance with the color scheme.
See section 3.4. of this manual for wiring information.
Hi-G-Tek Ltd. Microelectronics & Asset Tracking Technology
30
Remove the covers from the glands being used.
* Note: The electronics compartment panel should only be
opened by an authorised repair person. Unauthorized use
may result in loss of warrenty.
TB3
TB1
TB2