User's Manual

DataReader Installation
3
Hi-G-Tek Ltd. Microelectronics & Asset Tracking Technology
35
3.2. Indoor DataReader Installation
3.2.1. Connecting the Indoor Unit
* Note: The electronics compartment panel should only be
opened by an authorized repair person. Unauthorized use
may result in loss of warranty.
The indoor unit has three connector sockets at its base. Connector
socket P1 is for incoming communications and power-in. Socket
P3 is used to transfer power and to connect the unit to the next unit
in a daisy chain.
The DataReader should be mounted on a smooth, flat surface.
To mount the unit, insert 4 screws into the slots on the unit and
fix to the surface.
A 6mm plastic anchor and 35mm pan head tapping screw
is recommended.