User Manual

Chapter 2 Quick Start
- 20 - Hi-G-Tek Ltd. Micro electro nic s & A sset Tra cking Techno logy
2
Quick-Start
The aim of this chapter is to lead you step-by-step in the quickest way to
the stage where you can verify that the Demo System is working properly,
and that you have a simple syst em that you can play with, in order t o
evaluat e the potent ial of the product s. This guide a ssumes t hat t he
parameters of the DataReader and DataSeal are the factory defaults, and it
refers only to the Demo System. For installation instructions for a
DataReader that is not a Demo System, see chapter 5.
2.1 Before you begin
Before you begin, make sure that you have the following items available:
1. The Hi-G-T ek DataReader
device.
2. DataReader Antenna.
3. At least one Hi-G-T ek DataSeal device.
4. The Seal ID of the DataSeal (printed on the sticker on the bottom side
of the DataSeal).
5. Sealing Wire(s) (according to t he number of DataSeals. If you are using
DataTags you need Sensor Plate(s) instead of the Sealing Wires)
6. P C running one of the following operating syst ems:
• Windows 98 or above.
• Windows NT 4.0 or above.