User Manual

Chapter 2 Quick Start
- 26 - Hi-G-Tek Ltd. Micro electro nic s & A sset Tra cking Techno logy
From the Command Code drop down list , select Hard Wakeu p.
Copy the Seal ID of the DataSeal you want to wake up into the Seals/Tags
ID t ext box. The Seal ID is print ed on t he st icker on the bottom of t he
DataSeal.
Click the Command Execution button. The mouse cursor will change to
an hourglass icon for about 11.5 seconds and then return to a normal
pointer cursor.
If the DataSeal received the message, The Res ult box will show the
message "Command OK" in green letters. If not, verify that you typed the
Seal ID correctly in the Seals/Tags ID box, and that the DataSeal is nearby,
and try again. If you still don't get the green "Command OK" message, or
you see a different red message in the Resul t box, refer to chapter 9 for
troubleshooting.
If you're using a Dat aSeal (as opposed t o a Dat aTag), you now have t o
close the Sealing Wire by inserting its 2 ends to the 2 sockets in the
DataSeal. Push the ends inside the sockets as far as you can. (You should
hear a 'Click' when the wire end is fully inserted). If you're using a
DataTag, you should place the Sensor Plate in its appropriate place at the
bott om of the Dat aTag.
From the Command Code drop down list , select Set and then click the
Command Execution button. After about 4 seconds, a green "Command
OK" message should appear in the Resul t box.
Congratulations! Now your DataSeal is prepared for normal operation!