User Manual

Chapter 6 System Overview
- 84 - Hi-G-Tek Ltd. Micro electro nic s & A sset Tra cking Techno logy
12. Write Data – Writes data into a DataSeal's User Data area.
13. Reset Data – Erases all the data in a DataSeals’ User Data area.
14. Se t/Reset Status – Sets or resets specific flags of the DataSeal’s Lon g
Status.
15. Write Parameters – Writes new values to one or more DataSeal
parameters.
16. Read Parameters – Reads the values of one or more DataSeal
parameters.
17. Addressed Verify – The Addresse d Verify command is the same as
the Verify command except that it is applicable to only one DataSeal.
This command is most commonly used to verify that a specific
DataSeal is located within a DataReader’s Receiving Zone.
18. Multi Addressed Ve rify – T he Multi Addresse d Ve rify command is
the same as the Addressed Verify command, but is applicable t o up t o
7 DataSeals simultaneously.
19. Read Eve nts – Reads part of or all Events stored in the DataSeal’s
Events Memory.
20. Approve Open – Permits to open a DataSeal after it has been Se t. If
opened, both the DataSeal's Approve d O pen and the Tampered flags
will be set. This command is intended for recognizing permitted
DataSeal openings.
21. Start Forced Burst – Forces the DataSeal to send a special Burst
message called Forced Burst. It is most useful when this command is
executed in Low Frequency, and by that causing the DataSeal to send
information to the DataReader. When used in high frequency, it may be
executed in one DataReader, while a different DataReader (in another
place for example), should receive the Force d Bu rs t message.
22. Temporarily Disable HF – Disables the HF channel in a DataSeal for
a specified period. This is useful to conserve battery when the area may