User's Manual

SPDS wireless adaptor- User Manual Page 2
1. Introduction
The following instructions describe and illustrate the principle steps involved in installation of
RFID tags operating as SPDS bottom valve wireless adaptor and SPDS vapor pressure valve
wireless adaptor.
The SPDS tag is portable, reusable electronic device designed to monitors the access point
through sensors and generate status information and alarms corresponding to various
programmed conditions. The wireless adaptor tag uses RFID (Radio Frequency Identification)
wireless technology- and includes a transmitter/ receiver unit, read/write capability, real-time
clock, memory sensing circuitry for sealing verification.
2. Product Models
This manual described the use of the products listed in the following table.
Due to differences in regulations regarding the use of RF spectrum, a product should be used
according to the following table:
Model Number
Used in
IG-SPV-40-433
Europe or where the EU directives apply.
IG-SBV-40-433
IG-SBV-40-916
Where the FCC regulation apply.
Forbidden for use in Europe.
IG-SBV-40-916
3. Safety Precautions
NOTE: The SPDS wireless adaptor electronic tag is powered by internal,
irreplaceable 3.6V cell; do not drill into or attempt to open any part of the tag
housing.
USE HIGTEK APPROVED SERVICE
Only approved service personnel must work on this product.
HAZARDOUS ENVIRONMENT
The Use of wireless adaptor tag is subject to the product safety classification given in
section 6 : “ATEX product marking”, in this user guide. For all other safety aspects,
Please refer to the enclosed EC- type examination certificate (page 8)
ACCESSORIES
Use only approved accessories. Do not connect incompatible devices.
When connecting to any other device, please consult with Hi-G-Tek Engineering
Department prior to installation.