Shenzhen Hi-Link Electronic Co., Ltd. HLK-B30 User Manual 802.11n+BLE 4.
Contents 1. Product description....................................................................................................................................... 1 1.1. Basic parameters................................................................................................................................ 1 2. Main application areas.................................................................................................................................. 1 3. Product Overview.............
HLK-B30 Shenzhen Hi-Link Electronic Co., Ltd. Manual 1. Product description HLK-B30 is a new low-consumption wifi control module from Hi-Link Electronics. The module has built-in wifi network protocol and BLE Bluetooth protocol stack, which can realize fast distribution network through BLE. The module is embedded with a low-power 32-bit CPU, 2Mbyte memory, 256KB RAM and a wealth of peripheral resources. Integrates all wifi mac and TCP/IP protocols. 1.1. Basic parameters Support 802.
HLK-B30 Shenzhen Hi-Link Electronic Co., Ltd. Manual 3. Product Overview 3.1. Technical specifications Table 2-1 Product technical specifications Network standard Wireless standard: IEEE 802.11n, IEEE 802.11g, IEEE 802.11b Bluetooth standard: BLE 4.2 11n: up to 150Mbps Wireless transmission rate 11g: up to 54Mbps 11b: up to 11Mbps Channel 2.
HLK-B30 Shenzhen Hi-Link Electronic Co., Ltd. Manual 3.2. Hardware description HLK-B30 dimension as below: (L*W)=16mm*25mm Figure 1 HLK-B30 Dimension 3.3. Block diagram 26MH 3.
HLK-B30 Shenzhen Hi-Link Electronic Co., Ltd. Manual 3.4. Power supply requirements Power supply requirements Power input voltage DC:3.3±0.3V No-load operating current 130±50mA Supply current requirement ≥1000mA 3.5. WIFI transmission power consumption Wifi transmission power consumption Mode Rate Transmit power Current(ma) 11b 11Mbps 17.5dbm 280 11g 54Mbps 11dbm 150 11n MCS7 10dbm 130 3.6.
HLK-B30 Shenzhen Hi-Link Electronic Co., Ltd. Manual 3.8. Output power in each mode of WIFI Parameter RF average output power, 802.11b cck Mode 11m RF average output power, 802.11g OFDM Mode 54m RF average output power, 802.11n OFDM Mode MCS7 Frequency error Minimum value Typical value Maximum value Unit - 17.5 - dBm - 15 - dBm - 13 - dBm -10 - 10 ppm Minimum value Typical value Maximum value Unit - -91 - dBm - -74 - dBm - -70 - dBm 3.9.
HLK-B30 Shenzhen Hi-Link Electronic Co., Ltd. Manual 4. Test board description The test board is mainly used to demonstrate the functions of the HLK-B30 module's lanterns, sockets and lights. Use the test board to demonstrate remote switch LEDs, color changes, brightness changes, relay switch lights, etc. Figure 3 HLK-B30 Module test board 4.1. Switching light function description Before testing the switch light function, you need to use the serial port to burn the firmware of the switch light function.
HLK-B30 Shenzhen Hi-Link Electronic Co., Ltd. Manual 4.3.
HLK-B30 Shenzhen Hi-Link Electronic Co., Ltd. Manual After the distribution network is successfully connected, the app will automatically enter the control interface directly: Figure 6 HLK-B30 Distribution network completed 4.4.
HLK-B30 Shenzhen Hi-Link Electronic Co., Ltd.
HLK-B30 Shenzhen Hi-Link Electronic Co., Ltd. Manual Appendix A Document Revision History Version number 1.
2.2 List of applicable FCC rules FCC Part 15.247 2.6 RF exposure considerations This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body. 2.
FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
