User's Manual
Table Of Contents
- 1.1.Product Introduction
- 1.2.Product Features
- 1.3.Technical Specifications
- 1.4.Pin introduction
- 1.5.Product packaging
- Figure 1 HLK-B36 package size
- 1.6.Block diagram
- 1.7.Testboard description
- 1.8. Power requirements
- 1.9.WIFI transmission power consumption
- 1.10.WIFI receiving power consumption
- 1.11.Power consumption in each working mode of WIFI
- 1.12.Output power in each mode of WIFI
- 1.13.Receiving sensitivity in each mode of WIFI
- 2.Function description
- 3.ATAT command instructions
- 3.1.Query the current module version:at+ver
- 3.2.Local port operation:at+CLport
- 3.3.Set up the serial port:at+uart
- 3.4.SET DHCP:at+dhcpc
- 3.5.Set wifi connection mode:at+netmode
- 3.6.Set TCP connection mode:at+mode
- 3.7.Set the remote IP when the module is used as a cli
- 3.8.Set the remote port when the module is used as cli
- 3.9.Set parameter submission:at+net_commit
- 3.10.System restart /exit at command mode:at+reconn
- 3.11.Set the ssid and password of the module:at+wifi_co
- 3.12.Set the socket connection protocol:at+remote pro
- 3.13.Set network connection parameters:at+net_ip
- 3.14.Query STA mode network connection status:at+wifi_C
- 3.15.Query module MAC address :at+Get_MAC
- 3.16.Set the framing length:at+uartpacklen
- 3.17.Set framing time:at+uartpacktimeout
- 3.18.Set Bluetooth name:at+ble_name
- 4.AT command control code routine
- 5.Restore factory settings method
- 6.Bluetooth data transparent transmission
- 7.Bluetooth distribution network
- 8.Electrical characteristics
- 8.1.Electrical parameters
- 9.Appendix A Document revision history
第
27
页 共 34 页
Pic 15 Bluetooth transmission test
7. Bluetooth distribution network
The Bluetooth configuration network is to connect to Bluetooth, send the wifi name and
password to module, and then the module connects to router according to the received wifi name and
password.
In sta and ap modes, Bluetooth is turned on, and the module can be connected through the
Bluetooth of mobile phone.
After connecting the Bluetooth of module, click the Configure Networking button on the app to
enter the network configuration interface.