User's Manual
Table Of Contents
- 1.1.Product Introduction
- 1.2.Product Features
- 1.3.Technical Specifications
- 1.4.Pin introduction
- 1.5.Product packaging
- Figure 1 HLK-B36 package size
- 1.6.Block diagram
- 1.7.Testboard description
- 1.8. Power requirements
- 1.9.WIFI transmission power consumption
- 1.10.WIFI receiving power consumption
- 1.11.Power consumption in each working mode of WIFI
- 1.12.Output power in each mode of WIFI
- 1.13.Receiving sensitivity in each mode of WIFI
- 2.Function description
- 3.ATAT command instructions
- 3.1.Query the current module version:at+ver
- 3.2.Local port operation:at+CLport
- 3.3.Set up the serial port:at+uart
- 3.4.SET DHCP:at+dhcpc
- 3.5.Set wifi connection mode:at+netmode
- 3.6.Set TCP connection mode:at+mode
- 3.7.Set the remote IP when the module is used as a cli
- 3.8.Set the remote port when the module is used as cli
- 3.9.Set parameter submission:at+net_commit
- 3.10.System restart /exit at command mode:at+reconn
- 3.11.Set the ssid and password of the module:at+wifi_co
- 3.12.Set the socket connection protocol:at+remote pro
- 3.13.Set network connection parameters：at+net_ip
- 3.14.Query STA mode network connection status：at+wifi_C
- 3.15.Query module MAC address :at+Get_MAC
- 3.16.Set the framing length：at+uartpacklen
- 3.17.Set framing time：at+uartpacktimeout
- 3.18.Set Bluetooth name：at+ble_name
- 4.AT command control code routine
- 5.Restore factory settings method
- 6.Bluetooth data transparent transmission
- 7.Bluetooth distribution network
- 8.Electrical characteristics
- 8.1.Electrical parameters
- 9.Appendix A Document revision history
第
32
页 共 34 页
new host device per definition in §15.101.
Integrator is reminded to assure that these installation instructions will not be made
available to the end-user of the final host device.
The final host device, into which this RF Module is integrated" has to be labeled with an
auxiliary label stating the FCC ID of the RF Module, such as "Contains FCC ID:
2AD56HLK-B36
"This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions:
(1)this device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that may
cause undesired operation."
"Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment."
the Integrator will be responsible to satisfy SAR/ RF Exposure requirements, when the
module integrated into the host device.
Module statement
The single-modular transmitter is a self-contained, physically delineated, component for
which compliance can be demonstrated independent of the host operating conditions, and
which complies with all eight requirements of § 15.212(a)(1) as summarized below.
1) The radio elements have the radio frequency circuitry shielded.
2) The module has buffered modulation/data inputs to ensure that the device will comply