User's Manual
Table Of Contents
- 1.1.Product Introduction
- 1.2.Product Features
- 1.3.Technical Specifications
- 1.4.Pin introduction
- 1.5.Product packaging
- Figure 1 HLK-B36 package size
- 1.6.Block diagram
- 1.7.Testboard description
- 1.8. Power requirements
- 1.9.WIFI transmission power consumption
- 1.10.WIFI receiving power consumption
- 1.11.Power consumption in each working mode of WIFI
- 1.12.Output power in each mode of WIFI
- 1.13.Receiving sensitivity in each mode of WIFI
- 2.Function description
- 3.ATAT command instructions
- 3.1.Query the current module version:at+ver
- 3.2.Local port operation:at+CLport
- 3.3.Set up the serial port:at+uart
- 3.4.SET DHCP:at+dhcpc
- 3.5.Set wifi connection mode:at+netmode
- 3.6.Set TCP connection mode:at+mode
- 3.7.Set the remote IP when the module is used as a cli
- 3.8.Set the remote port when the module is used as cli
- 3.9.Set parameter submission:at+net_commit
- 3.10.System restart /exit at command mode:at+reconn
- 3.11.Set the ssid and password of the module:at+wifi_co
- 3.12.Set the socket connection protocol:at+remote pro
- 3.13.Set network connection parameters：at+net_ip
- 3.14.Query STA mode network connection status：at+wifi_C
- 3.15.Query module MAC address :at+Get_MAC
- 3.16.Set the framing length：at+uartpacklen
- 3.17.Set framing time：at+uartpacktimeout
- 3.18.Set Bluetooth name：at+ble_name
- 4.AT command control code routine
- 5.Restore factory settings method
- 6.Bluetooth data transparent transmission
- 7.Bluetooth distribution network
- 8.Electrical characteristics
- 8.1.Electrical parameters
- 9.Appendix A Document revision history
第
3
页 共 34 页
Serial port
transparent
transmission
Transmission rate
110-921600bps
TCP Client
1个
Software
parameters
Wireless network
type
STA/AP
Security
Mechanism
WEP/WPA-PSK/WPA2-PSK
Encryption type
WEP64/WEP128/TKIP/AES
Firmware upgrade
Firmware upgrade
Network protocol
IPv4, TCP/UDP
User configuration
AT+ command set, one-key intelligent configuration of
network distribution
1.4. Pin introduction
Table 2 Module pin interface
Pin
Network name
Type
Directions
1
CEN
I
Chip enable, high effective
2
P26_PWM5
I/O
Bluetooth connection status indicator
pin
1: Bluetooth is connected
0: Bluetooth is disconnected
3
P24_PWM4
I/O
P24,PWM4
4
P23_TDO_F_S0
I/O
P23,ADC3
5
P22_TDI_F_SI
I/O
ES0, enter at command mode/restore
factory settings, please pull up if not used,
same as P28