User's Manual

Input STN & BS

STN:

KNOWN

I.H:

BS:

T.H:

*Aim BS.

2) Retrieve the point (see the chapter 4.8),then the

display of “STN” will be refreshed, at the same

time ,the cursor moves to the input box of

“I.H”(instrument height);

[Note*]:Here, the “STN” can’t be null.

STN: Station name

I.H: Instrument height

T.H: Target height

3) Input the instrument height in the “I.H” input box;

4) Input the name of backsight point, as same as the

operation of “STN” input;

5) Input the target height in the “T.H’ input box, then aim

at backsight point, and press the key [ENT] to enter

the interface of “BS .check 1/2”. As shown below:

BS. check 2/2

DSP

MSR2

MSR1

BS. check 1/2

Cal HR:

HD:

dHD:

dHR:

91º42′34"

0º00"00′

DSP

MSR2MSR1

[DSP]

6) Press the key [DSP] to switch the display page;

7) Press the key [MSR1] or [MSR2] to start distance

measurement, if the distance measurement is on,it will

be stopped.(Pressing the key [5] can modify the

parameters of measurement). After a successful

measurement, the measured data will be displayed and

you can check by turning pages;