User's Manual

40
which as shown picture (3);
6) Pressing [ADD] can add data;
7) Pressing [DSP] can switch the interfaces of data;
8) Pressing [REC.] or [ENT] to record data with a prompt
“Finished”, and come back to the interface of stationing
interface.
6.4 Quick
This function can station quickly without the coordinates of
station and backsight, which is equal to free-station.
1) Press the key [4] or select “4.Quick” and press [ENT] to
enter the interface of “Quick” interface，as shown below . If
the station has been set station, there will be the default data
displayed;
KNOWN
Quick
0.300
123
12345
STN:
I.H:
BS:
m
AZ:
20.0000
1
2) Input a point name in the “STN” input box, or you can press
[ENT] or [KNOWN] to retrieve points. If the point name
doesn’t exist, the default coordinate of station is (0,0,0);
[Notice*]: The station name can’t be null.
3) Input the target point in the “I.H” input box, and then press
[ENT];
4) Input the azimuth in the “AZ” input box, and press [ENT]
with a prompt “Finished” and back to “Basic” interface.
6.5 Remote BM
When the Z coordinate of station is changed, you can
upgrade the coordinate based on measured point.The flow chart