User's Manual

(AB-AC)”;

MLM->AB-AC 1/2

MSR1

DSPMSR2

rSD:

rVD:

rHD:

MLM->AB-AC 2/2

MSR1

DSPMSR2

rAZ:

rV%:

rGD:

[DSP]

2) Aim at the start point A, then press [MSR1] and

[MSR2] to start point. After a successful measurement,

the measured data from A to station will be displayed;

3) Measure point “B”, “C”, “D”, ……,in order, then the

data of “A-B” will be displayed ;

4) Press [DSP] to switch to check the measured data of

two pages;

5) Pressing [▪] can change the target height;

6) Press [ESC] to exit this function, and return to the

program menu.

8.3.2 MLM (A-B,B-C)

The interface of this function is as below:

The operation of this function is same as it of the chapter

8.3.1 “MLM (AB-AC)”.

8.4 REM (Remote height)

REM is adequate for measuring the height of target when

the prism cannot be placed at the target point. Under ‘REM’

mode, you can place the prism on any point along the plummet

line of the target point to obtain the height of target.