User's Manual

63
calculated in the interface of “Bevel->Result”;
4) Pressing the key [DSP] to switch to check the result data on
the two pages;
5) Press [ENT] to enter the interface of “Rec. data”, you can
record the measured data;
6) Press [ESC] to return to the interface of “Bevel ->Input”.
8.7 Area & Girth
This function is used to calculate the area and perimeter of
the plane figure which is enclosed by the measured or input
points.
1) In the program menu ,press the key [8] or [ENT] after
moving the cursor to “Area & Girth”, then enter the
interface of “Area&Per.->Input”，as shown in figure
(1);
Pt.N:
Area and Per.->Input
MEAS
KNOWN
（1）
CALC
Area and Per.->Result
Area:
Girth:
*[ESC] back,[ENT] record
[CALC]
[ESC]
QUIT
*Input no 1pt.
（2）
10.000
23.508
sqm
m
2) Input the point name and retrieve or measuring the
point n. When you complete the input of one point, it
will enter the next point input automatically;
3) When the number of point input is three or more than
three, press [CALC] to enter the interface shown in
picture (2),the calculation of the area and perimeter will
be displayed;
4) Press [ENT] to record the data of area and perimeter,
then return back to the program menu;
5) In the interface (2),press the key [ESC],and return back
to the interface of “Area&Per.->Input”;