User's Manual

- 13 -
CONNECTIONS
Typical Time-Lapse Recorder Rear Panel
Optional Loop-out to another video device
Typical LCD monitor back
Camera or other video source
OUT
IN
VIDEO AUDIO
To make a normal connection to the monitor, bring a cord from a camera or other
video source to one of the BNC jacks or from a PC to the PC jack on the back of the
monitor. Either the left or right BNC jack can be used for input. The other jack may
be optionally connected to another user of the same signal.
Auto Termination
The input circuit of the monitor normally terminates the incoming cable in 75 , but
these BNCs jack are auto-terminating. When two cables are connected, the internal
termination is switched out, letting the final destination equipment provide the end
termination. This arrangement is also specially offered for the Y/C (S-Video) jacks.
PC
-
+
DC12V
AUDIO
VIDEO
S-VIDEO
PC