User's Manual

14
Remark: Due to the phone types and the WiFi router types, there are few cases though
rare that the booster won’t be linked successfully to the signal supervisor app, even after
our technical support. In such case:
* Please kindly switch to use LCD signal meter to assist your install and will have the
same result. And Bluetooth/WiFi disconnection won’t influence the booster working status
at all.
* Or please use different phone or change your WiFi router if you really want remote
monitor.
Please contact our tech support and we will see what the best arrangements can be for
you.
Step 3: Look for best outside signal and install outdoor antenna
The performance of the booster system is heavily dependent on the successful installation of
the outdoor antenna
3.1 Connect the booster with outdoor antenna
(1) Put the booster near to the location you would like to install in the future, or a place with
power outlet temporarily.
(2) Switch on the booster and make sure the signal supervisor app links with it smoothly.
(3)Connect the 16.4ft cable with the booster’s outdoor port. The booster supports hot plug.
(4) Then connect the window cable with 16.4ft cable and pull the window cable outside and
connect it with 49.2ft cable. In case window cable is not needed, connect the 16.4ft cable with
49.2ft cable directly.
(5) Connect the other side of 49.2ft cable with the outdoor antenna.
BoosterOutdoor Antenna Outdoor Cable
Through-Window Cable
Outdoor cable to Booster
49.2ft NM-SMAM 16.4ft SMAF-SMAM
SMA-Male to SMA-Female
(No drilled hole)