User's Manual

(1) Put the booster near to the location you would like to install in the future, or a place with

power outlet temporarily.

(2) Switch on the booster and make sure the signal supervisor app links with it smoothly.

(3)Connect the 16.4ft cable with the booster’s outdoor port. The booster supports hot plug.

(4) Then connect the window cable with 16.4ft cable and pull the window cable outside and

connect it with 49.2ft cable. In case window cable is not needed, connect the 16.4ft cable

with 49.2ft cable directly.

(5) Connect the other side of 49.2ft cable with the outdoor antenna.

Step 2: Install the outdoor antenna

Notes:

It is a must NOT to connect indoor antenna at this moment as it will influence the outside

signal finding.

2.1 Connect the booster with outdoor antenna.

BoosterOutdoor Antenna Outdoor Cable

Through-Window Cable

Outdoor cable to Booster

49.2ft NM-SMAM 16.4ft SMAF-SMAM

SMA-Male to SMA-Female

(No drilled hole)