Use and Care Manual

NGS Mach II User Guide v1.1
Programmable Module Installation
43
Retrieve Data —Non-CAN Vehicles
1. Select the Vehicle, Module, and Action (PMI-
Programmable Module Installation) from
the Main Menu.
1 )MODEL : 2003 CROWN VICTORIA 4.6L
2)MODULE: RCM - RESTRAINT CONTROL M
3)ACTION : PMI-PROGRAMMABLE MODULE
4)GO ->
SELECT ITEM AND PRESS TRIGGER TO START
2. Highlight GO and then press TRIGGER.
1 )MODEL : 2003 CROWN VICTORIA 4.6L
2)MODULE: RCM - RESTRAINT CONTROL M
3)ACTION : PMI-PROGRAMMABLE MODULE
4)GO ->
SELECT ITEM AND PRESS TRIGGER TO START
3. Highlight PROGRAMMABLE MODULE
INSTALLATION and then press TRIGGER
.
SERVICE BAY FUNCTIONS
PROGRAMMABLE MODULE INSTALLATION
GENERIC OBDII FUNCTIONS
VIEW REC AREAS
* RETURN TO MAIN MENU *
SELECT ITEM AND PRESS TRIGGER TO START
SUPPORT: MY 1994 TO CURRENT MY SCP ISO
APP ID : NON CAN SERVICE BAY
SELECT RETURN TO MAIN MENU ABOVE FOR
MY 2004 THRU CURRENT MY VEHICLES
4. Highlight the module and then press TRIGGER.
RCM -RESTRAINT CONTROL MODULE
REM -REAR ELECTRONIC MODULE
RESC -REMOTE EMER SATELLITE UNIT
SCIL -STEERING COLUMN/IP LIGHTING
SCLM -STEERING COLUMN LOCK MODULE
SELECT ITEM AND PRESS TRIGGER TO START
SUPPORT: MY 1994 TO CURRENT MY SCP ISO
APP ID : NON CAN SERVICE BAY
SELECT RETURN TO MAIN MENU ABOVE FOR
MY 2004 THRU CURRENT MY VEHICLES
d
u
NGS displays this screen:
- VERIFY THAT THE IGNITION IS IN THE
ON POSITION AND PRESS TRIGGER.
PRESS CANCEL TO EXIT
5. Start the vehicle, press TRIGGER to continue.
6. Highlight RETRIEVE MODULE CONFIG-
OLD ECU and then press TRIGGER.
RETRIEVE MODULE CONFIG-OLD ECU
RESTORE MODULE CONFIG-NEW ECU
SELECT ITEM AND PRESS TRIGGER TO START