Use and Care Manual

NGS Mach II User Guide v1.1
Programmable Module Installation
44
8. NGS displays this message:
- RETRIEVED DATA CAN BE STORED IN THE
NGS UP TO 48 HOURS. TO PREENT DATA
LOSS, DO NOT RETRIEVE MODULE DATA
UNTIL NEW MODULE IS AVAILABLE.
- PRESS TRIGGER TO CONTINUE.
PRESS CANCEL TO EXIT
• Press TRIGGER to continue
• Press CANCEL to exit to the previous
screen.
9. NGS begins to retrieve the data. Follow the
instructions on the screen to complete the
procedure.
10. When the inhale is complete, NGS displays
the following screen:
-PROCESS COMPLETE-
PRESS ANY KEY TO CONTINUE
Note: NGS displays the actual module selected.
12. To immediately exhale the data to the new
module:
• Proceed to Restore—Non-CAN Vehicles
and proceed to step 6.
Note: If you power off NGS Mach II
before you perform an exhale, proceed to
Restore—Non-CAN Vehicles step 1 instead.
NGS will save the inhaled data for 48
hours after powering down.
To return to the Service Bay Function screen:
• Press any key.
Restore Data —Non-CAN Vehicles
To exhale data immediately after an inhale,
proceed to step 6.
Note: If you powered off NGS Mach II, you will
need to start from step 1.
1. Select the Vehicle, Module, and Action (PMI-
Programmable Module Installation) from
the Main Menu.
1 )MODEL : 2003 CROWN VICTORIA 4.6L
2)MODULE: RCM - RESTRAINT CONTROL M
3)ACTION : PMI-PROGRAMMABLE MODULE
4)GO ->
SELECT ITEM AND PRESS TRIGGER TO START
2. Highlight GO and then press TRIGGER.
1 )MODEL : 2003 CROWN VICTORIA 4.6L
2)MODULE: RCM - RESTRAINT CONTROL M
3)ACTION : PMI-PROGRAMMABLE MODULE
4)GO ->
SELECT ITEM AND PRESS TRIGGER TO START
3. Highlight PROGRAMMABLE MODULE
INSTALLATION and then press TRIGGER
.
SERVICE BAY FUNCTIONS
PROGRAMMABLE MODULE INSTALLATION
GENERIC OBDII FUNCTIONS
VIEW REC AREAS
* RETURN TO MAIN MENU *
SELECT ITEM AND PRESS TRIGGER TO START
SUPPORT: MY 1994 TO CURRENT MY SCP ISO
APP ID : NON CAN SERVICE BAY
SELECT RETURN TO MAIN MENU ABOVE FOR
MY 2004 THRU CURRENT MY VEHICLES
4. Highlight the module and then press TRIGGER.