User's Manual

Table Of Contents

FlexSmart™ 607X Series Installation Guide – 6075-900, B.2

Figure 2 Keypad Reader Dimensions and Mounting

2.1 Mullion Mounting

The following describes how the readers mount to a mullion.

1. Drill two holes 6-32 or M-3 sheet metal or thread forming screws 3.3” (8.38 cm) apart.

2. Locate and drill a 0.375” (0.95 cm) hole for the reader cable.

3. Route the cable through the center hole to the controller.

4. Using the two 6-32 or M-3 screws, attach the reader to the first two mounting holes.

5. Once the reader module is screwed in place, snap on the bezel.

3 Wiring

3.1 Cable Types and Maximum Lengths

The MIFARE readers require a minimum voltage of 9.0 VDC. Voltage drops, caused by the cable

resistance, can be made by increasing the power supply voltage.

CAUTION: DO NOT SET THE POWER SUPPLY VOLTAGE TO HIGHER THAN 16 VDC.

CAUTION: DO NOT USE CABLES WITH GAUGES SMALLER THAN 24 AWG:

February 5, 2007 Page 5 of 8