User's Manual

ManualsBrandsHID Global ManualsElectronicsER40C , RFID Reader

Table Of Contents

Edge is the next evolution in access control hardware solutions. A true IP solution that meets the demands of open architecture, IP-centric

environments, Edge provides fully distributed intelligence and decision making right to the door, leveraging the IT infrastructure to the

maximum extent possible. Wire the Edge device to Hi-O interface modules to provide connectivity to electronic door components and

access control readers.

Hi-O involves devices with built-in intelligence and a CANbus that links all the devices together. Hi-O CANbus data trafc can be password

protected and encrypted, or both. Each Hi-O device (such as the push plate, electric strike, card reader, door operator) is connected to the

CANbus by a single, four-wire cable. Two of the wires supply power and the other two are used for data communication.

Specications

CONNECTION PARAMETER CONDITIONS VALUE

OPERATING

TEMPERTURE

CABLE LENGTH

PoE Power

(input)

Voltage - Nominal - 48 VDC

32° - 122°F

(0° - 50° C)

Hi-O CAN Bus

= 30 ft (9 m) - 22 AWG ● 0.65mm ● 0.33mm

= 75 ft (23 m) - 18 AWG ● 1.02mm ● 0.82mm

RJ45 = 328 ft (100 m) - Category 5 K

Current - Normal Standby

Condition (NSC)

CAN PWR - not loaded 75 mA

Current - Maximum CAN PWR - max load 275 mA

+DC (input)

Voltage - 12 VDC - 24 VDC

Current - Normal Standby

Condition (NSC)

12 VDC

CAN PWR disconnected

190 mA

Current - Normal Standby

Condition (NSC)

24 VDC

CAN PWR disconnected

110 mA

Current - Maximum 12 VDC 2.2 A

Current - Maximum 24 VDC 2.1 A

CAN PWR

(output)

Voltage - Nominal PoE 24 VDC

Current - Maximum PoE 300 mA

Voltage - Nominal + DC + DC

Current - Maximum + DC 2 Amp - AUX limited

Edge

EdgeReader® and EdgePlus®

Models: EH400, EHR40, EHRP40, EH400-K

ER40C, ERP40C

InstallatIon GuIde

82000-920, Rev A.1

December 10, 2009

15370 Barranca Parkway

Irvine, CA 92618-2215

USA

DRAFT

Summary of content (5 pages)

PAGE 1
Edge 15370 Barranca Parkway Irvine, CA 92618-2215 USA EdgeReader® and EdgePlus® Models: EH400, EHR40, EHRP40, EH400-K ER40C, ERP40C Installation Guide 82000-920, Rev A.1 December 10, 2009 © 2009 HID Global Corporation. All rights reserved. Edge is the next evolution in access control hardware solutions.
PAGE 2
EdgeReader and EdgePlus 82000-920 A.1 EH400, EHR40, EHRP40, EH400-K Mounting Junction box not included. Wiring RA FT EdgeReader and EdgePlus CAN Termination Resistor (Default - IN) Ethernet Activity LED 3.3 VDC LED CAN-LO (Brown) D CAN-HI (White) GND (Black) Hi-O Device CAN PWR (Red) GND DC In Ethernet / PoE Auto-Detected ATTENTION Observe precautions for handling ELECTROSTATIC SENSITIVE DEVICES ES400, ER40 or ERP40 (Rear View) 2 INSTALLATION GUIDE ©2009 HID Global Corporation.
PAGE 3
EdgeReader and EdgePlus 82000-920 A.1 EH400, EHR40, EHRP40, EH400-K EdgePlus - EH400-K Strike Common 6 Strike N.C. AUX N.O. AUX Common 1 Strike N.O. AUX PWR +V 12 1 P1 4 P3 AUX N.C.
PAGE 4
EdgeReader and EdgePlus 82000-920 A.1 EH400, EHR40, EHRP40, EH400-K Contact Contact Edge through one of the following methods: Direct Connect If Edge will be connected to a network using static IP addressing or if the Discovery GUI is not installed on the PC, use this method. Note: The computer must be running Windows 2000 or XP and be configured for DHCP. 1. Disconnect the computer from the network and directly connect Edge to the computer with an Ethernet cable. 2. Click Start > Run.
PAGE 5
Regulatory UL Connect only to a Listed Access Control / Burglary power-limited power supply, or Listed Access Control / Burglary PoE (Power-over-Ethernet) adapter. All National and local Electrical codes apply. Install in accordance with NFPA70 (NEC), Local Codes, and authorities having jurisdiction. Furthermore, install within a Listed electrical box. All interconnected devices must be Listed. Host-based security, Ethernet / Host Communication, has not been evaluated by UL.