User's Manual
Table Of Contents
- DTC5500LMX Card Printer User Guide
- 1 - Specifications
- 2 - Setup and Installation Procedures
- 3 - Printing Preferences
- 4 - ToolBox
- 5 - Troubleshooting
- 6 - Firmware Upgrades
- 7 - Technical Support
November 2015 PLT-02496, Version: 1.0
Page 4-3 To o l Box
4.2 Calibrate Laminator Tab
The Calibrate Laminator tab is active when the laminator is automatically detected or when
the laminator is manually checked as a feature on the Configuration tab.
Note: The lamination module must be warm before calibrating. Calibration may also be performed
from the printer LCD. See Section 3.10.2: Sensor Calibration Options.
To Calibrate the Laminator:
1. Ensure that the cartridges are out of the Laminator.
2. Ensure the Laminator cover is closed.
3. Click Calibrate.