Datasheet

125 kHz How to Order Guide - D00530, B.7

Indala 125kHz Credential

Every part number consists of a base model number to indicate the type of product, and a letter or number to indicate

each product option. Each Indala

product has a standard part number that includes default options, as indicated on

the order guide. When an order is placed for a product, the base model number and all options must be specified. If

you require any options that are different from the default options, you must also indicate those options at the time the

order is placed. All part numbers must be complete to be accepted by HID’s order entry system.

All card orders must have the following information:

• BASE MODEL NUMBER – Specifies card or type

• PROGRAMMING – Specifies if card is factory or field programmed (format or format number,

facility code, and ID number range must be given at time of order)

• FRONT or FLAT SIDE GRAPHICS – Specifies standard or custom artwork, and smart chip

placement

• BACK or EMBOSSED SIDE GRAPHICS – Specifies standard or custom artwork, and smart chip

placement

• MARKING POSITION – Specifies location of card marking.

Note: Card marking is surface printed and, therefore is not to be considered permanent. In

certain cases Laser etching may be used instead of inkjet marking. Laser etching is permanent

marking but is not used on all products.

• SLOT PUNCH – Specifies slot location if available

• CARD OPTIONS – Applies to FlexCard® (Base Model FPCRD/CXCRD) only

• MAGNETIC STRIPE OPTION – Specifies if card is to have a magstripe and which type (ISO

Imageable Cards only)

• CUSTOM FILE NUMBER – Specifies the artwork number to be used