Install Guide

Powering
Trusted Identities
January 2022PLT-06387, Rev. A.0 7
HID® MOD001
Install Guide
Specications
BEEKs BLE Module Model: MOD001
Available configurations
MOD001
(Most comprehensive)
MOD001-UART MOD001-Badge
Description
Base model board with
components to support generic
data input through I2C, SPI, and
analog sensors.
Board with components to
support serial data input via UART
connection; raw data advertised
in sBeacon packets.
Board with components to
support use of module in a badge
application for location service
use-cases
Dimensions
30.5mm x 23.5mm 30.5mm x 23.5mm 30.5mm x 23.5mm
Frequency Range
2400-2483.5 MHz
Number of Channels
40
Modulation
GFSK
Mode of operation
Half-duplex
RF output power (max)
+5 dBm
Data Rate
1 Mbit/s
Antenna
PCB antenna, antenna gain 0.30 dBi
External Antenna (optional)
TAOGLAS WCM.01.0111 2.4GHz Button Antenna. Antenna Gain 0.89 dBi
Power Supply
Input Voltage 3.6—30 VDC
Operating temperature
-22° to +140° F (-30° to +60° C)
Power consumption -RX
7.5 mA RX Active Mode
Power consumption-TX
6.5 mA TX Active Mode
Power consumption-sleep
1.6 μA (SRAM retention and RTC running)
CPU
Dual Code: ARM Cortex M3 (32 bit, 48 MHz) main CPU, ARM Cortex M0 (16 bit) sensor controller
Flash Memory
128 KB flash (MCU)
512 KB additional flash
Type Feature
BLE Stack
• Bluetooth Low Energy 4.2 compliant single mode protocol stack
• GAP, SM, GATT, ATT, L2CAP and Link layer protocols
• Peripheral and broadcaster roles
• Central role
• Observer and limited master role
• Fully embedded software architecture. No bifurcation between Host and Controller
Link-Layer
• Packets per connection interval - Configurable up to 12
• Connection parameters update
• Connection channel map update
• Connection graceful terminate
• AES128 Encryption request and response
Memory
• ~54 kB stack and application size (Flash non-volatile memory)
• ~8 kB RAM requirement
• No memory Isolation between application and protocol stack