User's Manual

ManualsBrandsHidrate ManualsElectronicsBluetooth Enabled Smart Water Bottle

Quick Start Guide

• Your Hidrate Spark bottle uses one CR2477

Lithium battery. During the battery replacement

process these batteries represent choking hazard.

• Product is NOT designed for hot liquids. Use only

with cold liquids.

• Adding ice can cause an inaccurate measurement.

• Not for use with carbonated or pulpy beverages.

• Prior to drinking, make sure the lid is properly

threaded to the body and screwed on completely.

• DO NOT overll. Fill liquids to the ll line or below

to avoid accidental spilling.

• DO NOT microwave or freeze.

• DO NOT use cleaners containing bleach, chlorine,

abrasives and/or harsh chemicals.

• DO NOT continue to use if product is damaged.

• DO NOT carry bottles containing liquid in bags to

help prevent accidental opening.

We’re here to support you.

If you ever need to contact us, here’s how:

Chat with us on our website

hidratespark.com

support@hidrate.me

In App

Settings > Help

For more information and best practices, please visit

hidratespark.com/pages/guide to review the user

manual.

BCD

A. Lid

B. Soft Grip Body

C. Sensor Stick

D. Finger Loop

E. Battery

F. Bottom Ring

ATTENTION

DESCRIPTION

REV DATE

HI-003-CM-USAPKG

001 06 / 22 / 2020

Note: This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

The FCC requires the user to be notied that any changes or modications

made to this device that are not expressly approved by HIdrateSpark may

void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to

the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause

undesired operation.

The user’s manual or instruction manual for an intentional or unintentional

radiator shall caution the user that changes or modications not expressly

approved by the party responsible for compliance could void the user’s

authority to operate the equipment. In cases where the manual is provided

only in a form other than paper, such as on a computer disk or over the

Internet, the information required by this section may be included in the

manual in that alternative form, provided the user can reasonably be

expected to have the capability to access information in that form.

FCC

This device complies with Innovation, Science and Economic Development

Canada’s licence-exempt RSSs. Operation is subject to the following two

conditions:

(1) This device may not cause interference; and

(2) This device must accept any interference, including interference that

may cause undesired operation of the device.

Cet appareil est conforme aux ux RSS exemptés de licence d’Innovation,

Science et Développement économique Canada. L’opération est soumise

aux deux conditions suivantes:

(1) Cet appareil ne doit pas provoquer d’interférence; et

(2) Cet appareil doit accepter toute interférence, y compris les interférences

susceptibles de provoquer un fonctionnement indésirable de l’appareil.

Radiation Exposure Statement: This equipment complies with the IC RSS-

102 radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with a minimum distance

of 20 cm between the radiator and your body.

Énoncé d’exposition aux rayonnements: Cet équipement est conforme

aux limites d’exposition aux rayonnements ioniques RSS-102 Pour un

environnement incontrôlé. Cet équipement doit être installé et utilisé avec

un Distance minimale de 20 cm entre le radiateur et votre corps.

ISEDC

Summary of content (2 pages)

PAGE 1
DESCRIPTION REV HI-003-CM-USAPKG 001 D AT E 06 / 22 / 2020 FCC Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These Quick Start Guide limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 2
B AT T E R Y I N S T R U C T I O N S • DOWNLOAD THE APP • Turn bottle upside down and unscrew the battery cover from the base of the bottle. turn right – tighten turn left – loosen • • Once the battery cover is removed insert battery into sensor. negative – • + positive • • The sensor will illuminate with a startup sequence. Lastly, secure battery cover back on base of bottle. DO NOT overtighten the screw when reassembling. Overtightening may cause damage to the product.