User Manual

Test

Step1

Test car stereo: ①The red and yellow wires of the car stereo combine together firstly

and then connected to the positive pole of the battery,② The black wire is connected to

the negative pole of the battery. ③ 2 seconds later, check the car stereo, if the screen is

lighting up, it means the car stereo is proper functioning.

A quick simple test before the installation is to confirm that the device is working normally

and as expected. In case there is a wrong step in the subsequent installation, which

causes it to fail to work. If you perform a successful test but the unit did not work after

installing it please recheck the installation steps.

①

②

Step2

Test rear view camera: Holding the

Step 1

connection. ④and then the pink wire is

connected with the top red wire of the rear view camera, ⑤ The middle red wire and

the bottom red wire of the rear view camera combine together and then connected to

the ① (which the red and yellow wires connected to the positive pole of the battery).

⑥The black wire of rear view camera is connected to②(which the black wire is connected

to the negative pole of the battery). At this time , if the camera lights up, and the car

stereo shows the reverse image, it means rear view camera is proper functioning.

①

④

⑤

⑥

②

4 5