Owner`s manual
12
20
ENG|OPERATIONAL INSTRUCTIONS
INTERCONNECTION EXAMPLE HIGHPASS/FULLRANGE: 1 x Speaker System
INTERCONNECTION AMPLIFIER 1
• Connect the RCA lineout L of the headunit with the RCA jacks LINE IN R & L of the amplifier with appropriate high-value RCA cables
and a Y-connector (1F/2M) to split the signal.
• Connect the speaker (left) with the speaker outputs (SPEAKER OUTPUTS + and - of the same socket) by using appropriate wires.
• Ensure by any means, that the total impedance load of all speakers is not lower than 2 ohms. Too low impedance cause high temperature
and will shut down the amplifier operation.
• Always ensure the correct polarity of the speakers. The interchange of plus and minus cause total loss of bass playback and could
damage the speakers.
INTERCONNECTION AMPLIFIER 2
• Connect the RCA lineout R of the headunit with the RCA jacks LINE IN R & L of the amplifier with appropriate high-value RCA cables
and a Y-connector (1F/2M) to split the signal.
• Connect the speaker (right) with the speaker outputs (SPEAKER OUTPUTS + and - of the same socket) by using appropriate wires.
• Ensure by any means, that the total impedance load of all speakers is not lower than 2 ohms. Too low impedance cause high temperature
and will shut down the amplifier operation.
• Always ensure the correct polarity of the speakers. The interchange of plus and minus cause total loss of bass playback and could
damage the speakers.
CROSSOVER SETTINGS AMPLIFIER 1 & 2 (Please use the same settings for both amplifiers)
• By using bigger speakers (more than 20cm) you can set the X-OVER MODE switch to the FULL position (Full Range Signal).
• By using smaller speakers (8.7cm - 16cm) you must set the X-OVER MODE switch to the HPF Position (Highpass Mode) to avoid
any damage by lower frequencies on the speakers. The cut-off frequency is adjustable with the HPF controller and should be set between
60Hz to 150Hz, depending on the size of the speakers.
• The LPF Controller is not in use in this interconnecting example.
LEVEL CONTROLLER AMPLIFIER 1 & 2 (Please use the same settings for both amplifiers)
• Turn the LEVEL controller of the amplifier to the MIN. position.
• Turn the volume controller of the headunit to 80 - 90% of its full setting.
• Turn the LEVEL controller clockwise until you hear some distortion.
• Then turn back the LEVEL controller slightly until you hear a cleaner sound.
BOOST CONTROLLER AMPLIFIER 1 & 2
• The BOOST controller must be turned to 0 dB position in this interconnecting example.
REMOTE BASS LEVEL CONTROLLER BLC-TR AMPLIFIER 1 & 2
• The enclosed remote BASS LEVEL Controller is not in use in this interconnecting example.