Owner`s manual

INTERCONNECTION

• Connect the RCA lineouts of the headunit with the RCA jacks LINE IN of the amplifier with appropriate high-value RCA cables.

• Connect the front- or rear speakers with the speaker outputs (SPEAKER OUTPUTS + L - and + R -) by using appropriate wires.

• Ensure by any means, that the total impedance load of all speakers is not lower than 2 ohms. Too low impedance cause high temperature

and will shut down the amplifier operation.

• Always ensure the correct polarity of the speakers. The interchange of plus and minus cause total loss of bass playback and could

damage the speakers.

CROSSOVER SETTINGS

• By using bigger speakers (more than 20cm) you can set the X-OVER MODE switch to the FULL position (Full Range Signal).

• By using smaller speakers (8.7cm - 16cm) you must set the X-OVER MODE switch to the HPF Position (Highpass Mode) to avoid

any damage by lower frequencies on the speakers. The cut-off frequency is adjustable with the HPF controller and should be set between

60Hz to 150Hz, depending on the size of the speakers.

• The LPF Controller is not in use in this interconnecting example.

LEVEL CONTROLLER

• Turn the LEVEL controller of the amplifier to the MIN. position.

• Turn the volume controller of the headunit to 80 - 90% of its full setting.

• Turn the LEVEL controller clockwise until you hear some distortion.

• Then turn back the LEVEL controller slightly until you hear a cleaner sound.

BOOST CONTROLLER

• The BOOST controller must be turned to 0 dB position in this interconnecting example.

REMOTE BASS LEVEL CONTROLLER BLC-TSi

• The enclosed remote BASS LEVEL Controller is not in use in this interconnecting example.

INTERCONNECTION EXAMPLE 2-Channel Mode: 1x Stereo System (Front or rear)

OPERATIONAL INSTRUCTIONS|ENG

Connect RCA output (L/R) of the

headunit with LINE IN of the amplifier

L R

Loudspeaker

left

2 – 8 Ohms

Loudspeaker right

2 – 8 Ohms

Position XOVER MODE:

HPF or FULL