Manual

Version 5.2 Features and Enhancements Summary
Release 5.2 is the initial release of the new DVC710 Master Module. The DVC710 Master Module has been
designed to carry a greater feature set then previous versions of the DVC Master Module product line while
maintaining a lower cost rugged solution to sophisticated hydraulic and industrial motion control applications.
New Features
o J1455 Load Dump compatibility
o Dual CAN ports, DVC DeviceNet and J1939 compatible
o Enhanced J1939 bus handling features
o 3
ea
, 0 – 3 Amp proportional auto-ranging current controlled sinking outputs
o Analog and Universal Inputs configurable as Digital inputs (Active Low)
o 4 LED on board system Health / Operation Indicating System
o Enhanced Status LED Control
o Configurable System Disable input (Dig_1)
o 1
ea
, 5 Volt 500mA reference output
o Up to 512 configurable EEMEM variables
o 40MHz µProcessor (4 X faster than DVC5, DVC7 or DVC10)
o Temperature Shutdown variable, Normal/Warning /Shutdown
o NMEA0183 RS232 Protocol Support for Maritime applications
o J1939 message enable/disable and message specific source address
o Variable PWM frequency (0-100 hertz) and duty cycle control.
o PWM% configurable Universal inputs 30Hz to 1.5 KHz
o Software supports - Windows XP, Windows 7 Home Premium, Windows 7 Professional, and Windows
Ultimate, (32 or 64bit)
o Data Logging feature using the Virtual Display
o Removed the Ramp feature from Analog and Universal Input Configurations
P/N: 021-00163, Rev. A.0 - for V5.2 Tools Page | 5