Software User guide

Electronic Controller Solutions for the Global Fluid Power Industry
epc-2 & evc-2 Specification Overview ( General ):
1. Module size/format: High Country Tek Inc. Mobile ‘easy-mount’ format
2. Design Standards: Full CE classification
3. Power Supply type and range: 10 to 32VDC (max)
4. Recommended module protection: 5A AGC fuse in power supply line
5. User stabilized voltage: + 5VDC ±10%
6. Output current: 500mA (max)
7. Protection: Current limited, short circuit protected
8. Digital Input number: 3x ON/OFF inputs
9. Digital Input type: DCV - level shift
10. Digital input values: 0V to +VPower supply max
11. Universal input number: 2x inputs
12. Universal input type: DC voltage or DC Current
13. Universal input values: 0 to +5v or 4 to 20mA
14. Voltage Command I/P Impedance: 10 KOhm
15. Current command shunt resistor value: 100 Ohms
16. Proportional Output number: 2x PWM
17. Protection: Open and short circuit protection
18. Proportional output Current: 0 to 3 amps max
19. Digital Output number: 6x High Side
20. Digital output type: ON/OFF level shift
21. Proportional output Current: 0 to 3 amps max
22. Protection: Open and short circuit protection
23. Digital output values: 0V to +V module supply voltage -0.5VDC
24. Operating Temperature range: -40C to +85C
25. Storage temperature range: -40C to +100C
26. Ingress protection rating: IP 68 / NEMA 6P
27. Connector type: Metri-Pack 30 way male
REMOTE ENABLE Important Note:
 The Enable input is DIGI 1 ( connector pin S2 ) and is configured to be active HIGH
 The user MUST pull the input ‘S2’ to +V supply to allow normal operation.
 The enable input is failsafe, with the input pin ‘S2’ pulled LOW ( 0V ) internally.
Contact HCT customer service or your nearest HCT Product distributor for other
connection/Hardware configurations if required
3